| amp: | 1 | mix: | 1 | pre_mix: | 1 | pre_amp: | 1 |
| cutoff: | 100 | res: | 0.5 |
with_fx :rlpf
Dampens the parts of the signal that are higher than the cutoff point (typically the crunchy fizzy harmonic overtones) and keeps the lower parts (typically the bass/mid of the sound). The resonant part of the resonant low pass filter emphasises/resonates the frequencies around the cutoff point. The amount of emphasis is controlled by the res opt with a higher res resulting in greater resonance. High amounts of resonance (rq ~1) can create a whistling sound around the cutoff frequency.
Choose a higher cutoff to keep more of the high frequencies/treble of the sound and a lower cutoff to make the sound more dull and only keep the bass.
Introduced in v2.0
| amp: |
The amplitude of the sound. Typically a value between 0 and 1. Higher amplitudes may be used, but won’t make the sound louder, they will just reduce the quality of all the sounds currently being played (due to compression.)
Default: 1
|
| mix: |
The amount (percentage) of FX present in the resulting sound represented as a value between 0 and 1. For example, a mix of 0 means that only the original sound is heard, a mix of 1 means that only the FX is heard (typically the default) and a mix of 0.5 means that half the original and half of the FX is heard.
Default: 1
|
| pre_mix: |
The amount (percentage) of the original signal that is fed into the internal FX system as a value between 0 and 1. With a pre_mix: of 0 the FX is completely bypassed unlike a mix: of 0 where the internal FX is still being fed the original signal but the output of the FX is ignored. The difference between the two is subtle but important and is evident when the FX has a residual component such as echo or reverb. When switching mix: from 0 to 1, the residual component of the FX’s output from previous audio is present in the output signal. With pre_mix: there is no residual component of the previous audio in the output signal.
Default: 1
|
| pre_amp: |
Amplification applied to the input signal immediately before it is passed to the FX.
Default: 1
|
| cutoff: |
MIDI note representing the highest frequencies allowed to be present in the sound. A low value like 30 makes the sound round and dull, a high value like 100 makes the sound buzzy and crispy.
Default: 100
|
| res: |
Filter resonance as a value between 0 and 1. Large amounts of resonance (a res: near 1) can create a whistling sound around the cutoff frequency. Smaller values produce less resonance.
Default: 0.5
|