| amp: | 1 | mix: | 1 | pre_mix: | 1 | pre_amp: | 1 |
| freq: | 30 | mod_amp: | 1 |
with_fx :ring_mod
Attack of the Daleks! Ring mod is a classic effect often used on soundtracks to evoke robots or aliens as it sounds hollow or metallic. We take a ‘carrier’ signal (a sine wave controlled by the freq opt) and modulate its amplitude using the signal given inside the fx block. This produces a wide variety of sounds - the best way to learn is to experiment!
Introduced in v2.3
| amp: |
The amplitude of the sound. Typically a value between 0 and 1. Higher amplitudes may be used, but won’t make the sound louder, they will just reduce the quality of all the sounds currently being played (due to compression.)
Default: 1
|
| mix: |
The amount (percentage) of FX present in the resulting sound represented as a value between 0 and 1. For example, a mix of 0 means that only the original sound is heard, a mix of 1 means that only the FX is heard (typically the default) and a mix of 0.5 means that half the original and half of the FX is heard.
Default: 1
|
| pre_mix: |
The amount (percentage) of the original signal that is fed into the internal FX system as a value between 0 and 1. With a pre_mix: of 0 the FX is completely bypassed unlike a mix: of 0 where the internal FX is still being fed the original signal but the output of the FX is ignored. The difference between the two is subtle but important and is evident when the FX has a residual component such as echo or reverb. When switching mix: from 0 to 1, the residual component of the FX’s output from previous audio is present in the output signal. With pre_mix: there is no residual component of the previous audio in the output signal.
Default: 1
|
| pre_amp: |
Amplification applied to the input signal immediately before it is passed to the FX.
Default: 1
|
| freq: |
Frequency of the carrier signal (as a midi note).
Default: 30
|
| mod_amp: |
Amplitude of the modulation
Default: 1
|