| amp: | 1 | mix: | 1 | pre_mix: | 1 | pre_amp: | 1 |
| output: | 1 | mode: | 0 |
with_fx :sound_out_stereo
Outputs a two-channel stereo signal to two consecutive soundcard outputs of your choice. By default will route the left and right channels of the incoming stereo signal (generated within the FX block) into separate left and right output channels. However, with the mode: opt, it is possible to alternatively cross over the channels or mix the incoming stereo channels into a single mono output and duplicate that on both left and right output channels.
Introduced in v3.0
| amp: |
The amplitude of the sound. Typically a value between 0 and 1. Higher amplitudes may be used, but won’t make the sound louder, they will just reduce the quality of all the sounds currently being played (due to compression.)
Default: 1
|
| mix: |
The amount (percentage) of FX present in the resulting sound represented as a value between 0 and 1. For example, a mix of 0 means that only the original sound is heard, a mix of 1 means that only the FX is heard (typically the default) and a mix of 0.5 means that half the original and half of the FX is heard.
Default: 1
|
| pre_mix: |
The amount (percentage) of the original signal that is fed into the internal FX system as a value between 0 and 1. With a pre_mix: of 0 the FX is completely bypassed unlike a mix: of 0 where the internal FX is still being fed the original signal but the output of the FX is ignored. The difference between the two is subtle but important and is evident when the FX has a residual component such as echo or reverb. When switching mix: from 0 to 1, the residual component of the FX’s output from previous audio is present in the output signal. With pre_mix: there is no residual component of the previous audio in the output signal.
Default: 1
|
| pre_amp: |
Amplification applied to the input signal immediately before it is passed to the FX.
Default: 1
|
| output: |
First of two consecutive sound card outputs to send audio to. Indexing starts at 1 and two outputs are used. Therefore an output of 2 will send audio to both outputs 2 and 3
Default: 1
|
| mode: |
Output mixing mode. Mode 0 is standard - left audio on the first channel, right on the second. Mode 1 is inverse - right audio on the first channel, left on the second. Mode 2 is mono - a mixed mono version of both channels is sent to both audio outputs.
Default: 0
|