| amp: | 1 | mix: | 1 | pre_mix: | 1 | pre_amp: | 1 |
| krunch: | 5 |
with_fx :tanh
Forces all audio through a hyperbolic tangent function which has the effect of acting like distorted limiter. It works by folding loud signals back in on itself. The louder the input signal, the more folding occurs - resulting in increased strange harmonics and distortion. This folding also has the effect of limiting the outgoing signal, therefore to increase the output amplitude use the amp: opt and to increase the folding/distortion use the pre_amp: opt.
Introduced in v2.9
| amp: |
The amplitude of the sound. Typically a value between 0 and 1. Higher amplitudes may be used, but won’t make the sound louder, they will just reduce the quality of all the sounds currently being played (due to compression.)
Default: 1
|
| mix: |
The amount (percentage) of FX present in the resulting sound represented as a value between 0 and 1. For example, a mix of 0 means that only the original sound is heard, a mix of 1 means that only the FX is heard (typically the default) and a mix of 0.5 means that half the original and half of the FX is heard.
Default: 1
|
| pre_mix: |
The amount (percentage) of the original signal that is fed into the internal FX system as a value between 0 and 1. With a pre_mix: of 0 the FX is completely bypassed unlike a mix: of 0 where the internal FX is still being fed the original signal but the output of the FX is ignored. The difference between the two is subtle but important and is evident when the FX has a residual component such as echo or reverb. When switching mix: from 0 to 1, the residual component of the FX’s output from previous audio is present in the output signal. With pre_mix: there is no residual component of the previous audio in the output signal.
Default: 1
|
| pre_amp: |
Amplification applied to the input signal immediately before it is passed to the FX.
Default: 1
|
| krunch: |
Higher values progressively destroy the sound. Achieved through a balanced manipulation of pre_amp and amp such that the tanh is pushed harder with higher krunch values yet the overall amplitude stays similar.
Default: 5
|