| amp: | 1 | pan: | 0 | attack: | 0 | decay: | 0 |
| sustain: | 0 | release: | 1 | attack_level: | 1 | decay_level: | sustain_level |
| sustain_level: | 1 | env_curve: | 2 | cutoff: | 110 | res: | 0 |
use_synth :cnoise
Generates noise whose values are either -1 or 1. This produces the maximum energy for the least peak to peak amplitude. Useful for generating percussive sounds such as snares and hand claps. Also useful for simulating wind or sea effects.
Introduced in v2.0
| amp: |
The amplitude of the sound. Typically a value between 0 and 1. Higher amplitudes may be used, but won’t make the sound louder, they will just reduce the quality of all the sounds currently being played (due to compression.)
Default: 1
|
| pan: |
Position of sound in stereo. With headphones on, this means how much of the sound is in the left ear, and how much is in the right ear. With a value of -1, the sound is completely in the left ear, a value of 0 puts the sound equally in both ears and a value of 1 puts the sound in the right ear. Values in between -1 and 1 move the sound accordingly.
Default: 0
|
| attack: |
Amount of time (in beats) for sound to reach full amplitude (attack_level). A short attack (i.e. 0.01) makes the initial part of the sound very percussive like a sharp tap. A longer attack (i.e 1) fades the sound in gently. Full length of sound is attack + decay + sustain + release.
Default: 0
|
| decay: |
Amount of time (in beats) for the sound to move from full amplitude (attack_level) to the sustain amplitude (sustain_level).
Default: 0
|
| sustain: |
Amount of time (in beats) for sound to remain at sustain level amplitude. Longer sustain values result in longer sounds. Full length of sound is attack + decay + sustain + release.
Default: 0
|
| release: |
Amount of time (in beats) for sound to move from sustain level amplitude to silent. A short release (i.e. 0.01) makes the final part of the sound very percussive (potentially resulting in a click). A longer release (i.e 1) fades the sound out gently. Full length of sound is attack + decay + sustain + release.
Default: 1
|
| attack_level: |
Amplitude level reached after attack phase and immediately before decay phase
Default: 1
|
| decay_level: |
Amplitude level reached after decay phase and immediately before sustain phase. Defaults to sustain_level unless explicitly set
Default: sustain_level
|
| sustain_level: |
Amplitude level reached after decay phase and immediately before release phase.
Default: 1
|
| env_curve: |
Select the shape of the curve between levels in the envelope. 1=linear, 2=exponential, 3=sine, 4=welch, 6=squared, 7=cubed
Default: 2
|
| cutoff: |
MIDI note representing the highest frequencies allowed to be present in the sound. A low value like 30 makes the sound round and dull, a high value like 100 makes the sound buzzy and crispy.
Default: 110
|
| res: |
Filter resonance as a value between 0 and 1. Large amounts of resonance (a res: near 1) can create a whistling sound around the cutoff frequency. Smaller values produce less resonance.
Default: 0
|