Normalised Resonant Band Pass Filter

amp: 1 mix: 1 pre_mix: 1 pre_amp: 1
centre: 100 res: 0.5

with_fx :nrbpf

Like the Band Pass Filter but normalised, with a resonance (slight volume boost) around the target frequency. This can produce an interesting whistling effect, especially when used with larger values for the res opt.

The normaliser is useful here as some volume is lost when filtering the original signal.

Introduced in v2.3

Options

amp:

The amplitude of the sound. Typically a value between 0 and 1. Higher amplitudes may be used, but won’t make the sound louder, they will just reduce the quality of all the sounds currently being played (due to compression.)

Default: 1
Must be zero or greater
May be changed whilst playing
Has slide options to shape changes

mix:

The amount (percentage) of FX present in the resulting sound represented as a value between 0 and 1. For example, a mix of 0 means that only the original sound is heard, a mix of 1 means that only the FX is heard (typically the default) and a mix of 0.5 means that half the original and half of the FX is heard.

Default: 1
Must be a value between 0 and 1 inclusively
May be changed whilst playing
Has slide options to shape changes

pre_mix:

The amount (percentage) of the original signal that is fed into the internal FX system as a value between 0 and 1. With a pre_mix: of 0 the FX is completely bypassed unlike a mix: of 0 where the internal FX is still being fed the original signal but the output of the FX is ignored. The difference between the two is subtle but important and is evident when the FX has a residual component such as echo or reverb. When switching mix: from 0 to 1, the residual component of the FX’s output from previous audio is present in the output signal. With pre_mix: there is no residual component of the previous audio in the output signal.

Default: 1
Must be zero or greater
May be changed whilst playing
Has slide options to shape changes

pre_amp:

Amplification applied to the input signal immediately before it is passed to the FX.

Default: 1
Must be zero or greater
May be changed whilst playing
Has slide options to shape changes

centre:

Centre frequency for the filter as a MIDI note.

Default: 100
Must be a value greater than or equal to 0
May be changed whilst playing
Has slide options to shape changes

res:

Filter resonance as a value between 0 and 1. Large amounts of resonance (a res: near 1) can create a whistling sound around the cutoff frequency. Smaller values produce less resonance.

Default: 0.5
Must be zero or greater,must be a value less than 1
May be changed whilst playing
Has slide options to shape changes